+- PLE forum (https://www.forum.ple4win.nl)
+-- Forum: Support (https://www.forum.ple4win.nl/forum-5.html)
+--- Forum: PLE User Interface (https://www.forum.ple4win.nl/forum-29.html)
+--- Thread: Bug of bend component (/thread-335.html)
Bug of bend component - peipei - 28-08-2012
Hi, everyone,
Recently I find a strange situation in my model.
The bend radius of one component which in the input table of "POLYDIF" is 1981.2mm. However, this bend radius is 0 in the output table "SHAPEP". See component 25VB2.
[admin: resized images]
Is there anyone ever had this problem?
Regards
RE: Bug of bend component - P Herwig MSc - 28-08-2012
Hi peipei,
I checked your issue with a colleague. The Radius is set to 0 in SHAPEP because the calculated bend length becomes less then 0.2 times the specified bend element length (in POLYDIF). In your case the bend length is approximately 8 [mm] whilst the specified bend element length is 50 [mm].
If I am correct you should have got warning W200/4: "Zero bend angle with radius". Unfortunately this is not a very proper warning for this situation since the bend angle is not near zero, but the calculated element length is too small. The warning will be either adapted or a new warning will be added to notify the user that the Radius is set to 0 due to a bend length less then 0.2 times the specified bend element length. This issue is noted as ticket J-335.
RE: Bug of bend component - peipei - 28-08-2012
Hi, Herwig,
Thanks for the reply. What is your suggestion in this case?
RE: Bug of bend component - P Herwig MSc - 28-08-2012
Hi peipei,
If you are sure that you want this very small bend, reduce the bend element length for 25BV2 in the POLYDIF table (a lenght of 30 [mm] should do). This change might require you to reduce the length of adjacent elements as well.
RE: Bug of bend component - P Herwig MSc - 09-05-2016
This warning description was extended in version 4.2.2.