This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
PLE forum › Support › PLE User Interface v
Default values doesn't work when a cursor is blinking in a cell

Thread Closed 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Default values doesn't work when a cursor is blinking in a cell
24-03-2016, 04:43 PM,
#4
P Herwig MSc
Unregistered
 		 
RE: Default values doesn't work when a cursor is blinking in a cell
Note that the <Esc> key will also cancel changes made to the cell being edited. After removing the "0", leave the cell (e.g. click another cell and hit <Esc> to leave edit mode there or simply click the Workspace panel title). The cell is now blank empty and - if not in edit mode - will accept the default value.
Thread Closed 


Messages In This Thread
RE: Default values doesn't work when a cursor is blinking in a cell - by P Herwig MSc - 24-03-2016, 04:43 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)