This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
PLE forum › Pipeline strength and stability analysis › General Technical Matters
No supports possible in inclined parts of the pipeline

Thread Closed 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
No supports possible in inclined parts of the pipeline
17-08-2011, 04:29 PM,
#2
Dr. J Foerster Offline
Administrator
*******
 		Posts: 133
Threads: 8
Joined: Sep 2008
Reputation: 0
RE: No supports possible in inclined parts of the pipeline
Ple4Win does allow supports on inclined parts of the pipeline. However, a warning is given if the inclination is greater than 5 deg., an error occurs if the inclination is grater than 20 deg. This is done because the way support forces are currently calculated is only valid for more or less horizontal supports.

We assigned ticket no. 1053 to your request.
Find
Thread Closed 


Messages In This Thread
RE: No supports possible in inclined parts of the pipeline - by Dr. J Foerster - 17-08-2011, 04:29 PM
RE: No supports possible in inclined parts of the pipeline - by P Herwig MSc - 24-03-2016, 11:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)