This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Combined bends
18-12-2014, 01:04 AM,
Combined bends
How do I model overlapping bends in horizontal and vertical plane,
without getting an overlap error?
18-12-2014, 12:26 PM,
RE: Combined bends
You cannot model overlapping bends, nor in practice, nor in Ple4Win. Whether the bends are in the horizontal and vertical plane does not matter. You will have to decrease the bend radius of one or both bends (see bottom left) or move one or both bends (see bottom right).

Forum Jump:

Users browsing this thread: 1 Guest(s)