This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Out of plane stress intensifaction factor
04-02-2017, 06:29 PM, (This post was last modified: 06-02-2017, 10:19 PM by shaswin.)
Out of plane stress intensifaction factor
I think there is some misunderstanding in the stress intensification factor outplane for miter bends and normal bends, see attached files.


In the NEN 3650-1:2012 the outplane stress intensification factor is not the same as ASME B31.8 Appendix E. In the NEN 3650-1 D.6.3/D.6.4 SIX is switched between normal and miter bends. Also the reference [70] is not correct in D.6.4 of the NEN 3650-1.

Is this correct? According to the attached file "mijterbocht" the NEN 3650 is followed in Ple4Win.

I have sent this also to the Dutch code commission, see page 13 of the attached file "CORRECTIES NEN 3650-serie rev46-compressed.pdf".

Attached Files
.pdf   mijterbocht.pdf (Size: 50,99 KB / Downloads: 4)
.pdf   ASME B31.8 Appendix E.pdf (Size: 343,89 KB / Downloads: 2)
.pdf   CORRECTIES NEN 3650-serie rev46-compressed.pdf (Size: 1,7 MB / Downloads: 0)

Forum Jump:

Users browsing this thread: 1 Guest(s)